AURORA FILTERS Common Features
The AURORA FILTERS is essentially a Nutsche-type filter with an upper chamber that acts as a glove box with a temperature controlled jacket zone and product chute outlet and a bottom chamber is the filtrate reservoir. The upper and lower chamber is separated by the filter plate which supports the filter media. The entire filtration operation is contained in an inert environment.
While each AURORA FILTERS is custom fabricated for each customer, the core engineering behind each AURORA FILTERS is sound. Here are some common features that go into each AURORA FILTERS.
- AURORA FILTERS are available in two different models – A-Series and P-Series.
- The A-Series are the original AURORA FILTERS and are designed for Atmospheric conditions in the upper chamber and vacuum conditions in the lower chamber
- The P-Series have been designed to allow for pressure and vacuum conditions throughout the filter without having the remove the gloves under these conditions as this design includes the Glove Port Equalization system.
- AURORA FILTERS are available in four different material types – 316LSS, 316LSS with HALAR lining, 316LSS with ETFE lining, and Hastelloy C22
- Interior surfaces of the 316LSS and Hastelloy C22 are mechanically polished to 0.5mRA
- Exterior surfaces of all filters are mechanically polished to 0.8mRA
- All surfaces are analyzed for potential hold-up points
- AURORA FILTERS are available in various sizes. Each size translates to a minimum and maximum cake development capacity.
- Eight common process connections – Slurry inlet, Nitrogen inlet, CIP wash inlet, Vent, Nitrogen inlet for drying, Final vacuum outlet, Filtrate vacuum outlet, and Product chute outlet.
- These connections can be fabricated from a variety of different flange types
- Product Chutes are available in various configurations
- Additional nozzles can be added upon request
- Each AURORA FILTERS has a large viewing window in the upper chamber as well as a small sight glass in the filtrate reservoir.
- With the glove box feature the chemists are able to touch and see the product throughout the filtration process
- The Heating/Cooling jacket is normally designed to 75psi for a variety of heat transfer fluids and is registered to ASME Code and can also be built to CE/PED standards. The jacket area surrounds the cake development area of the filter.
- The upper and lower chambers are separated at a flange connection where the filter plate is located which supports the filter media.
- Filter media is not supplied with the AURORA FILTERS. Customers are required to source their own preference for filter media to suit their needs.
- AURORA FILTERS can be supplied to handle traditional Cloth Filter Media or Wire Mesh Filter Media, or a combination of both options.
- The smaller filters (14” and 20”) have mechanical ACME thread assisted systems for raising and lowering the lower chamber to separate the filter and access the filter media.
- The larger filters (26”, 36”, and 48”) are supplied with hydraulic handling systems which offer maintenance free operation.
- Filters are supplied with
- All wet side gaskets are Teflon or Teflon encapsulated
- CIP Sprayball assembly in Teflon, 316LSS, or Hastelloy C22 material. Sprayball assembly can be removed from the filter without disassembly.
- One set of Hypalon Dry-Box gloves. Other materials can be special ordered.
- Glove clamps, product chute bag clamps, polypropylene product scoops, operational tools and toolbox
- Complete Operational and Maintenance Manual, Quality Assurance History Docket, Factory Acceptance Test Protocol and Report all ready for Site Acceptance Testing and customer Equipment Validation.
- Spare Parts list supplied with pricing that is held for 12 months from purchase.
- 12 month warranty for manufacturers materials and quality of workmanship